Swann SWVID-PENBL4 Instrucciones de operaciones Pagina 4

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 8
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 3
4
Video Mode
Picture Mode
Recording video from power o
1. Make sure the PenCam is o and that the selection switch inside the Pencam set
to Video Mode.
2. Press and hold the button. A blue and orange light will illuminate simultaneously
for about two seconds. Keep holding the button until the blue light disappears
leaving just the orange light glowing. The PenCam is now in video standby
mode.
3. From video standby mode, press the button to start recording. The orange light
will change to blue to indicate recording.
4. Press the button again to end recording. The camera will save the video to its
memory and the blue light will change back to orange to indicate it is back in
standby mode.
Note: Plugging the PenCam into a USB port during recording will stop the recording.
Taking pictures from power o
1. Make sure the PenCam is o and
that the selection switch inside the
PenCam is set to Picture Mode.
2. Press and hold the power/record
button. A blue and orange light will
illuminate simultaneously for about
two seconds. Keep holding the
button until the blue light disappears
leaving just the orange light blinking.
The PenCam is now in picture
standby mode.
3. Press the button once to take a
picture. The blue light will ash to
indicate the photo is being taken.
Hold the camera steady during this
period until the camera returns to
standby mode (orange light).
Standby mode = Orange
light
Static for video mode
Blinking for picture mode
Record mode = Blue light
Blue light ashes while
video recording
Blue light ashes once
when picture taken
Note: The PenCam switches itself o after 60 seconds in standby mode to pre-
serve battery life.
Press the button again to turn it back on.
Vista de pagina 3
1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios