Swann SWVID-PENBL4 Instrucciones de operaciones descargar pdf (Pagina 3)

Picture

mode

Video

mode

Turning the PenCam On

• Press the power/record button (on top o the pen) and hold until the both the

orange and blue lights turn on then release it. When the camera is ready to use

the orange standby light will stay on and the blue light will turn o.

• The orange light will blink when it is on standby in picture mode or stay lit when

it is on standby in video mode.

Turning the PenCam O

• Leave the Pencam in standby mode and it will automatically turn o after 60

seconds of inactivity

• The PenCam will not switch o while it is actually recording.

• If the PenCam is recording you must press the button once to stop recording and

return to standby (static orange light) then leave the camera for 60 seconds until

the orange light turns o indicating that the Pencam has turned o automatically.

Operating the Pencam

Switching between Video and Picture

To switch between Video and Picture mode,

unscrew the PenCam to reveal the USB

connector. Using the tip of a pen or ngernail,

move the selection switch (pictured) to the

right for PICTURE or left for VIDEO.

Charging the PenCam

The PenCam has a built in lithium-ion battery that provides approximately 45

minutes of power when fully charged.

Charge the PenCam by connecting the hidden USB connector inside the PenCam to

a USB port on your computer. The status LED will slowly ash orange while charging.

Full charge time is approximately 90 minutes. The PenCam will stop ashing when it

is fully charged.

IMPORTANT NOTE: Before using the PenCam for the rst time, connect it to a USB

port and charge it fully. The PenCam will not function as a camera while it is plugged

into the USB port.

1 2 3 4 5 6 7 8

Sin comentarios

Swann SWVID-PENBL4 Instrucciones de operaciones Pagina 3