Swann PRO-750 Guía para resolver problemas descargar pdf (Pagina 9)

9

1. Connecting the Camera Cable

Before mounting the camera, it is important

to connect it correctly.

1. Run the cable through the mounting

arm or bracket you would like to use.

2. Make sure you run the cable through

starting with the camera end (not the

end with the BNC connectors - they’re

too big to ﬁt).

3. Once the cable has been pulled through,

plug it into the top of the camera.

4. If you’re planning to mount the dome

outside, cover the screw threads with

a silicon sealant before screwing the

unit together. Failing to do so will

compromise the waterprooﬁng of the

dome.

5. Then, screw the mounting arm/bracket

onto the dome.

Be careful not to damage the connectors

on the end of the cable or to the camera,

particularly when unplugging the camera, as

the connectors are fragile!

2. Connecting the RS485 Cables

1. Remove the RS485 plug from the back

of the PTZ controller.

2. Insert the WHITE wire into the -B side of

the RS485 plug, and screw into place.

3. Insert the PURPLE wire into the +A side

of the RS485 plug, and screw into place.

4. Plug the RS485 plug into the RS485 port

on the back of the PTZ controller.

Note: If you need a longer cable to reach

the location you’d like to put the PTZ

controller, the RS485 cable can be extended.

If you are unfamiliar with cable construction

and maintenance, we suggest getting a

professional to do this.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comentarios a estos manuales

Sin comentarios